Doorking gate operators manual

DoorKing, Inc. reserves the right to make changes in the products described in this manual gate which moves in an arc in a horizontal plane that is intended for use for vehicular entrance and exit to a drive, parking lot, or the like. SYSTEM: In the context of these requirements, a system refers to a group of interacting devices intended to. DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons of any such revisions gate and gate operator and are familiar with the possible hazards associated with the gate. DoorKing does not provide a power transformer on units sold into Canada. Use only transformers that are CSA listed to power the telephone entry system. , .

Page 4 C Glossary GATE: A moving barrier such as a swinging, sliding, raising, lowering, or the like, barrier, that is a stand-alone. The operator is intended for installation only on gates used for vehicles. Pedestrians must be supplied with a separate access opening. The pedestrian access opening shall be designed to promote pedestrian usage. Locate the gate such that persons will not come in contact with the vehicular gate during the entire path of travel of the vehicular gate. These DoorKing manuals are the most up-to-date versions and may not be applicable to older DoorKing driveway gate equipment with the same model numbers. Contact us for older DoorKing manuals and for manuals for other gate equipment models. Need assistance or can’t find your DoorKing gate manuals? Please contact our service department at Experienced service technicians are here to answer your questions and provide onsite service; emergency service available 24/7 if your gate.

Model 90Vehicular Slide Gate Operator Owner's Manual. Use this manual with all 90operators with circuit board Leave Manual with Owner. Circuit Board. Serial Number and Revision Letter: EXTERNAL ENTRAPMENT PROTECTION MUST be installed or the gate operator WILL NOT. Connect device(s) to be activated (gate operator, door strikes, etc.) to relay terminals as required. See pages 7. Adjustments (Section ). 1. Make a.